Tisma Series FlexiPro Wraparound Casepacker

BW Integrated Systems’ TISMA Series FlexiPro Wraparound Casepacker is a fully automatic case packaging system designed to end-load a variety of products into wraparound cases. When paired with our integral loader and infeed system, the FlexiPro automatically feeds a corrugated blank, erects it, positions the case for loading and closed and seals the flaps in preparation for palletizing.

  • Up to 20 cases per minute; final speed dependent on product and product orientation
  • Walk-in area for improved access
  • Low-profile magazine for easier loading
  • Allen-Bradley PanelView HMI with diagnostic alarms
  • Nordson hot melt glue system
  • Allen-Bradley Logix series PLC
  • Inside manufacturer’s joint 

Case Size Range

Length: 8” (203.2mm) minimum to 15” (381mm) maximum

Height: 5” (127mm) minimum to 12” (304.8mm) maximum

Width: 8” (203.2mm) minimum to 20” (508mm) maximum

Electrical Requirements 

Incoming Voltage - 240/480 volts, 3-phase, 60 Hz

Control Voltage - 24VDC

Hot Melt Circuit – 240-volt, 60 Hz, 1 to 3 phase (optional transformer available if incoming voltage is other than 240)

Current Draw - Dependent on loader

Air Requirements

Operating Pressure - 80 psi

Line Pressure - 90 psi

Maximum Free Air Consumption - 1.24 cu ft. per cycle

Hot Melt Air Pressure - 20 to 60 psi

  • Servo main drive
  • Low level tray detection
  • Beacon light to indicate casepacker operation
  • Open flap detection
  • Additional magazine length
  • Ethernet interface
  • UL listed electrical enclosure
  • Digital indicators and calibrated scales