Tisma Series FlexiPro Knockdown Casepacker

BW Integrated Systems’ TISMA Series FlexiPro Knockdown Casepacker is a fully automatic case packaging system designed to end-load a variety of products into a regular slotted case (RSC). When paired with our loader and infeed system, the FlexiPro automatically feeds corrugated blanks from horizonal magazines, positions the blanks for loading, folds the blanks around the end product and closes and seals the flaps and joints in preparation for palletizing.

  • Up to 20 cases per minute when using RSC corrugated containers; final speed dependent on product and product orientation
  • AC variable speed drive
  • Ergonomically designed walk-in area
  • Single 12” high mechanical pusher beam transfer
  • Mechanical positive motion, cam-driven, vacuum erecting system
  • Low-level case detection
  • Automatic advance horizontal magazine for ease of loading
  • Servo main drive

Case Size Range

Length: 8” (203.2mm) minimum to 24” (609.6mm) maximum

Height: 5” (127mm) minimum to 16” (406.4mm) maximum

Width: 6” (152.4mm) minimum to 20” (508mm) maximum

Electrical Requirements

Incoming Voltage - 240/480 volts, 3-phase, 60 Hz

Control Voltage - 24VDC

Hot Melt Circuit – 240 volts, 60 Hz, 1 to 3 phase (optional transformer available if incoming voltage is other than 240)

Current Draw - Dependent on loader

Air Requirements

Operating Pressure - 80 psi

Line Pressure - 90 psi

Maximum Free Air Consumption - 1.24 cu ft. per cycle

Hot Melt Air Pressure - 20 to 60 psi